硬件和射频工程师

 找回密码
 立即注册
查看: 271|回复: 1

Need help with DRC errors in EAGLE CAD.

[复制链接]
发表于 2014-10-12 00:00:00 | 显示全部楼层 |阅读模式
















I am getting a few DRC errors in eagle CAD
I just want to know if they can be ignored or fixed.

1) Dimension: I have used the 3.5 mm jack kibrary provided by sparkfun
However on Design Rule Check it is showing the dimension error.
Should I make any amends or it is fine to ignore this error?

2) Drill Size: I didn't quite understand what exactly is wrong here.

3) Overlap: Here wire of the same signal is overlapping with the pad and the via.
Is it fine to ignore this error or I need to make amends?

4) Stop mask: I am getting this error in two of the libraries I myself have made.
Is it fine to ignore the error? Or is it necessary to change the layer from tplace to tdocu?

5) Width: The ICs I am using have the pad width of around 8~9mil.
So accordingly I have kept the wire width to 9mil as well.
Also the operating current is in micro amperes.
So is it still necessary to increase the width of the wires?
回复

使用道具 举报

发表于 2014-10-12 00:00:00 | 显示全部楼层
Your images don't show the actual error report.

1) Looks like it can be ignored.
2) not sure here either - what is it saying is the error?
3) I would not want a hole through my SMT pads, I'd move it if I was doing this.
回复 支持 反对

使用道具 举报

您需要登录后才可以回帖 登录 | 立即注册

本版积分规则

Archiver|手机版|小黑屋|硬件和射频工程师  

GMT+8, 2018-7-19 14:08 , Processed in 0.136920 second(s), 22 queries .

Powered by Discuz! X3.2

CoprRight © 20011-2014 hwrf.com.cn

快速回复 返回顶部 返回列表